Table of Contents  MOBOTIX Online Help

Thermal Spotmeter

Table of Contents
Thermal Spotmeter
General Settings of the Thermal Spotmeter
Show Crosshairs
Alarm Type
Temperature Unit
Trigger Values
Comparison
Action Type

The thermal spotmeter can trigger events based on the measured temperature. The measurement area covers the four pixels at the center of the image.

Important Notes

General Settings of the Thermal Spotmeter

Show Crosshairs

In order to exactly point the sensor to the object you want to measure, the camera can display crosshairs in the live image. The circle at the center of the crosshairs shows the four pixels that are used for measuring.

Alarm Type

Allows using a temperature level (single trigger value) or a temperature range (two trigger values).

Temperature Unit

Show the temperatures either in degrees Centigrade (°C) or Fahrenheit (°F).

Trigger Values

Enter the temperature value that is used to trigger an event when it exceeds or when it drops below the value (depending on the setting of the Comparison parameter).

Comparison

Select between triggering the event when it exceeds or drops below the specified trigger value on the one hand or when it reaches or leaves the specified temperature range.

Action Type

Define how often the event is to be triggered:


Storing the Configuration

Click on the Set button to activate your settings and to save them until the next reboot of the camera.

Click on the Factory button to load the factory defaults for this dialog (this button may not be present in all dialogs).

Click on the Restore button to undo your most recent changes that have not been stored in the camera permanently.

Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.


© 2001-2020 MOBOTIX · https://www.mobotix.com