Table of Contents  MOBOTIX Online Help

Temperature Table

Table of Contents
Temperature Table
Displayed Temperatures
Current Temperatures
Temperature History
Description of Parameters

The Temperature Table dialog presents the temperatures measured by the camera or a corresponding hardware expansion (e.g. a MOBOTIX ExtIO) in a structured table.

If your MOBOTIX camera is attached to such a hardware expansion, open the Manage Hardware Expansions dialog to configure the expansion.

Displayed Temperatures

Current Temperatures

The Current Temperatures section shows the current time/date and the measured temperatures (reloading the page will update these temperatures). In addition, you can set an offset (positive or negative) that will be added to the measured temperature (and thus also to the Temperature History).

Temperature History

The Temperature History section lists the temperatures measured every hour during the last four days in a table.

  • Rows: Time (hours)

  • Columns: Days (format MM-DD)

If a temperature field contains ---- the camera could not obtain any temperature measurements (e.g., because the camera or the hardware expansion had been switched off).

Description of Parameters

Option

Parameter

Offset °C

You can use the temperature offset (in degrees Centigrade) to correct small deviations from the temperatures measured by the camera or hardware expansion to the actual temperatures. The camera applies the offset to the current temperature as well as all measurements recorded in the temperature table.

See also

Displaying the text in the camera images:


Storing the Configuration

Click on the Set button to activate your settings and to save them until the next reboot of the camera.

Click on the Factory button to load the factory defaults for this dialog (this button may not be present in all dialogs).

Click on the Restore button to undo your most recent changes that have not been stored in the camera permanently.

Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.


© 2001-2024 MOBOTIX · https://www.mobotix.com